Circular Ceiling Diffuser with & without damper
March 5, 2020
FL-TZ Architectural Slot Diffuser for TechZone Systems
March 5, 2020
FBBO Blank-Off for Flowbar Diffusers
Blank-Off for Flowbar Diffusers
Titus FBBO is used to create inactive sections of FlowBar by blocking airflow.
Description
FEATURES AND BENEFITS
- Units ship in 6-foot increments, field cut for a shorter length
- Five different sizes in ½” increments, ranging from a 1” slot to 3” slot
- Optional blank-off (painted flat black)
- Can be used to block light from plenum space
OPTIONAL MITERED CORNER
FBMC-10 / 1” Slot
FBMC-15 / 1½” Slot
FBMC-20 / 2” Slot
FBMC-25 / 2½” Slot
FBMC-30 / 3” Slot
- End Caps, End Borders, Mitered Corners, and Blank-Offs are optional
- FlowBar Diffusers can be joined together end-to-end to form long continuous runs
- Optional End Borders and End Caps close off the ends of the diffusers and simplify installations ending at walls and other stopping points
- Optional Mitered Corners are rendered inactive with factory-installed blank-offs
- Spline Clips (SS1) maintain tight joints between sections
OPTIONAL FIELD CUT SPACER KIT
HTSK-10 / 1” Slot
HTSK-15 / 1½” Slot
HTSK-20 / 2” Slot
HTSK-25 / 2½” Slot
HTSK-30 / 3” Slot
JTSK-10 / 1” Slot
JTSK-15 / 1½” Slot
JTSK-20 / 2” Slot
JTSK-25 / 2½” Slot
JTSK-30 / 3” Slot
Sometimes the exact length of a FlowBar diffuser is not known until the diffuser is being installed. Standard FlowBar diffusers can be field trimmed. Use the following information to trim FlowBar in the field.
- Determine the desired length and cut accordingly
- Insert the optional field cut spacer kit
- Place the spacer kit ¼ inch from the newly trimmed end
Note: The pattern controller must be cut 1¼ inches shorter than the borders to accommodate the Field Spacer Kit. The following figures illustrate the trimming
procedure.
Reviews (0)
Reviews
There are no reviews yet.